Yamaha RX-A3000 Owner's Manual page 45

SOURCE RECEIVER
iCursor B / C
7 Press
the "Measure" and press
AV
measurement.
1 2 3 4
5 6 7 V-AUX
Auto measurement starts in 10 seconds.
AUDIO
1 2 3 4
PHONO MULTI USB NET
• To start the measurement immediately, press
DOCK TUNER SIRIUS
[ A ] i
ENTER
again.
• To cancel the automatic setup, press
i
then ENTER.
Display during measurement
YPAO
P r o g r e s s
i
ENTER ENTER
RETURN RETURN
NOTE
If a problem occurs, an error message or report is
displayed either during or after acoustic measurement.
Refer to "When an error message is displayed during
measurement"
message is displayed after measurement"
resolve the problem and measure acoustics with
YPAO again.
repeatedly to select
iENTER to start
i
RETURN and
M e a s u r i n g . . .
VOLUME
0 %
(☞p. 49), or "When a warning
(☞p. 50) to
■ When "Multi Position" is set to "No" in
step 5
The calculation based on result of measurement starts
when measurement finishes without any problem.
When "Angle" is set to "No" in step 6
The following display appears when the calculation
finishes without any problems.
YPAO M e a s u r e . F i n i s h
S a v e / E x i t
Go to step 14.
When "Angle" is set to "Yes" in step 6
The following display appears when the calculation
finishes without any problems.
YPAO A n g l e M e a s u r e ?
> Y e s N o
Go to step 9.
CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
■ When "Multi Position" is set to "Yes" in
step 5
The following display appears when measurement at the
first position finishes without any problems.
YPAO M L T . P o s i t i o n 2 ?
> Y e s
VOLUME
Go to step 8.
VOLUME
VOLUME
N o
Continues to the
next page
45
En