Setting This Unit's Video Output Function - Yamaha RX-A3000 Owner's Manual

■
Adjusting DSP effect and volume level
Adaptive DSP Level
Automatically adjust the level of DSP effect in conjunction with
the volume level.
Off Disables automatic adjustment of the level of DSP
effect.
On (Default) Adjusts the degree of DSP effect in conjunction with
volume level. The higher the volume level, the less the
DSP effect applied. The lower the volume level, the
greater the DSP effect applied.
This feature also corrects sound effect according to
the result of automatic measurement.

Setting this unit's video output function

Video setup items
Analog to Analog Enable or disable video conversion between analog
Conversion video jacks.
Processing
Enable or disable adjustment of resolution, aspect
ratio and video signal correction for video signal
converted to HDMI video.
J
1 : This item can be set when set "Processing" to "On."
■
Analog-to-analog video conversion
Analog to Analog Conversion
Enables or disables video conversion between analog video jacks.
Off Disables video conversion between analog video
jacks.
On (Default) Enables video conversion between analog video jacks.
• Analog-to-HDMI video conversion is always possible unless
video signals are being input at the HDMI input jacks or 1080p-
resolution analog video signals are being input
• This unit does not convert 480 line video signals and 576 line
video signals interchangeably.
• 480p-, 576p-, 1080i- and 720p-resolution video signals can not
be output at the S-video and video jacks of MON.OUT/ZONE
OUT (☞p. 167).
• The converted video signals are only output at the MONITOR
OUT jacks.
• When composite video or S-video signals from a VCR are
converted into component video signals, the picture quality may
suffer depending on your VCR.
• Unconventional signals input at the composite video or S-video
jacks cannot be converted or may be output abnormally. In such
cases, set "Analog to Analog Conversion" to "Off."
Setting various functions (Setup menu)
■
Adjusting video with conversion of video
signal to HDMI
Processing
Adjust video with conversion of video input to HDMI video.
Off (Default)
On
J1
Resolution
Auto (Default)
(☞p. 167).
480p (576p)
720p
1080i
1080p
Through
• When a TV is connected to this unit via the HDMI jack, this unit
automatically detects a resolution that the TV supports. Only the
detected resolution can be selected.
• If this unit cannot detect the resolution that the TV supports, set
"MONITOR CHECK" in the Advanced Setup menu to "SKIP"
(☞p. 146) and try again.
SETUP
Video are not adjusted with processing.
Video are adjusted with processing.
Automatic upscaling in accordance with TV
resolution.
Upscaling to 480p (576p).
Upscaling to 720p.
Upscaling to 1080i.
Upscaling to 1080p.
No upscaling.
121
En