Intel Amt Webgui; Connecting With The Intel Amt Webgui - Smb Example - HP 8100 - Elite Convertible Minitower PC Setup And Configuration Manual

Intel AMT WebGUI

The Intel AMT WebGUI is a web browsre-based interface for limited remote system
management.
The WebGUI is often used as a test to determine if AMT Setup and Configuration
was performed properly on a system. A successful remote connection between a
remote system and the host system running the WebGUI indicates proper AMT
Setup and Configuration on the remote system.
The AMT WebGUI is accessible from the following web browsers:
Microsoft Internet Explorer 6 SP1 or newer
•
Netscape Navigator 7.1 or newer
•
Mozilla Firefox 1.0 or newer
•
Mozilla 1.7 or newer
•
Limited remote system management includes:
Hardware inventory
•
Event logging
•
Remote system reset
•
• Changing of network settings
• Addition of new users and passwords
Updating ME firmware
•
WebGUI support is enabled by default for SMB Setup and Configured systems.
WebGUI support for Enterprise Setup and Configured systems is determined by the
Setup and Configuration Server.

Connecting with the Intel AMT WebGUI - SMB Example:

1) Power on an AMT system that has completed AMT Setup and Configuration.
2) Execute a web browser from a separate system – a Management PC that is
also on the same subnet as the AMT PC.
3) Connect to the IP address specified in the MEBx and port of the AMT
system.
a. By default the port is 16992.
b. If DHCP was used, then use the Fully Qualified Domain Name (FQDN) for
the ME. The FQDN is the combination of the hostname and domain.
Example A: http://192.168.0.1:16992 (IPv4 address)
Example B: http://hpsystem.hp.com:16992
Example C: http://[2001:ABC::ABC]:16992 (IPv6 address)
4) The Management PC makes a TCP connection to the AMT system and
accesses the top level AMT embedded webpage within the Management
Engine of the AMT system.
5) Enter username and password. The default username is "admin" and the
password is the one set during AMT Setup in the MEBx.
23