Sd Card Problems; Usb Drive Key Problems; Fan Problems - Compaq 234664-002 - ProLiant - ML330T02 Troubleshooting Manual

Run HP Insight Diagnostics (on page 74). Then, replace failed components as indicated.
3.
When the drive is a replacement drive on an array controller, be sure that the drive is the sam
4.
and of th
Data is inaccessible
Action:
Be sure th
1.
Be sure no viruses exist on the server. Run a current v
2.
When a TPM is installed and is being used with BitLocker™, be sure th
3.
("HP ROM-Based Setup
operating system documentation.
When migrating encrypted data t
4.
operating system documentation.
Server response time is slower than usual
Action:
Be sure the hard drive is not full. If needed, increa
1.
recommends that hard drives have a minimu
Review information about the operating system encryption technology, which can ca
2.
in server performance. For more information, see the operating system documentation.
SD ca rd problems
System does not boot from the drive
Action:
Be sure the drive boot order in RBSU is set so that the s
1.
Reseat the SD card.
2.
USB drive k ey problems
System do s not boot from the drive e
Action:
Be sure that USB is enabled in RBSU.
1.
Be sure the drive boot order in RBSU is set so that the server boots from the USB drive key.
2.
Reseat the USB drive key.
3.

Fan problems

Genera a l f n problems are occurring
Actio n:
e same or larger capacity than the original drive.
e files are not corrupt. Run the repair utility for the operating system.
Utility" on page 65). See the TPM replacement recovery proce
ersion of a virus scan utility.
o a new server, be sure to follow the recovery procedures in the
se the amount of free space on the hard drive. HP
m of 15 percent free space.
erver boots from the SD card.
e type
e TPM is enabled in RBSU
dure in the
use a decrease
Hardware problems 44