Removing A Cabled Hard Drive - Dell PowerEdge T410 Hardware Owner's Manual

4 With the lever on the hard drive carrier open, slide the hard drive into the
drive bay until the carrier contacts the backplane. See Figure 3-7.
5 Push in (towards the system) on the hard drive carrier and rotate the
handle up until it snaps into place. See Figure 3-7.
6 Replace the front bezel. See "Installing the Front Bezel" on page 86.

Removing a Cabled Hard Drive

WARNING:
cover and access any components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 Disconnect the power and data cable from the hard drive in the drive bay.
5 Press the blue tabs on each side of the hard-drive bracket towards each
other and slide the drive up and out of the bay. See Figure 3-9.
98
Installing System Components
Only trained service technicians are authorized to remove the system