Installing A Cabled Hard Drive - Dell PowerEdge T410 Hardware Owner's Manual

Figure 3-10. Removing a Hard Drive From a Hard Drive Bracket
1 hard drive
NOTE:
If you are not replacing the hard drive, remove the drive from the drive
bracket (see Figure 3-10) and insert the empty bracket back into the drive bay.
7 Close the system. See "Closing the System" on page 91.
8 Place the system upright and on its feet on a flat, stable surface.
9 Rotate the system feet outward.
10 Reattach any peripherals and connect the system to an electrical outlet.
11 Turn on the system and attached peripherals

Installing a Cabled Hard Drive

WARNING:
cover and access any components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
100
Installing System Components
Only trained service technicians are authorized to remove the system
2 hard drive bracket
1
2