Removing An Idrac6 Express Card - Dell PowerEdge T410 Hardware Owner's Manual

Figure 3-19. Removing and Installing an iDRAC6 Express Card
5
1 iDRAC6 Express card
3 iDRAC6 Express card connector
5 clip

Removing an iDRAC6 Express Card

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
128
Installing System Components
1
4
Only trained service technicians are authorized to remove the system
3 2
2 retention standoff tab clip
4 notch