Installing The Chassis Intrusion Switch; Control Panel Assembly (Service-Only Procedure); Removing The Control Panel Assembly - Dell PowerEdge T410 Hardware Owner's Manual

1 chassis intrusion switch
3 INTRUSION connector on the system
board

Installing the Chassis Intrusion Switch

1 Align the chassis intrusion switch with the securing bracket notch.
See Figure 3-25.
2 Slide the switch into the securing bracket notch. See Figure 3-25.
3 Connect the chassis intrusion switch cable to the connector on the
system board.
4 Close the system. See "Closing the System" on page 91.
5 Place the system upright and on its feet on a flat, stable surface.
6 Rotate the system feet outward.
7 Reattach any peripherals and connect the system to an electrical outlet.
8 Turn on the system and attached peripherals.

Control Panel Assembly (Service-Only Procedure)

Removing the Control Panel Assembly

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Remove the bezel. See "Removing the Front Bezel" on page 85.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
3 Rotate the system feet inward and lay the system on a flat surface.
4 Open the system. See "Opening the System" on page 90.
CAUTION:
the cable.
142
Installing System Components
Only trained service technicians are authorized to remove the system
Do not pull the cable to unseat the connector. Doing so can damage
2 chassis intrusion switch cable