Installing The Chassis Intrusion Switch - Dell PowerEdge T110 II Owner's Manual

5 Remove the switch and its attached cable from the system.
Figure 3-24. Removing and Installing the Chassis Intrusion Switch
1 chassis intrusion switch
3 INTRUSION connector

Installing the Chassis Intrusion Switch

1 Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-24.
2 Slide the switch into the securing bracket notch.
3 Connect the switch cable to the INTRUSION connector on the system
board. See Figure 6-1.
4 Close the system. See "Closing the System" on page 60.
1
2
3
2 securing bracket notch
Installing System Components
103