If you do not enter the correct password in three attempts, the system lets you
view, but not modify, the System Setup screens—with the following
exception: If System Password is not set to Enabled and is not locked through
the Password Status option, you can assign a system password (however, you
cannot disable or change an existing system password).
NOTE:
You can use the Password Status option in conjunction with the Setup
Password option to protect the system password from unauthorized changes.
Deleting or Changing an Existing Setup Password
1 Enter the System Setup program and select the System Security option.
2 Highlight the Setup Password option, press <Enter> to access the setup
password window, and press <Enter> twice to clear the existing setup
password.
The setting changes to Not Enabled.
3 If you want to assign a new setup password, perform the steps in "Assigning
a Setup Password" on page 62.
Disabling a Forgotten Password
See "Disabling a Forgotten Password" on page 174.
Baseboard Management Controller Configuration
The Baseboard Management Controller (BMC) enables configuring,
monitoring, and recovery of systems remotely. BMC provides the following
features:
•
Uses the system's integrated NIC
•
Enables fault logging and SNMP alerting
•
Provides access to system event log and sensor status
•
Allows control of system functions including power on and off
•
Functions independently of the system's power state or the system's
operating system
Using the System Setup Program
63