Figure 3-30. SAS/SATA Backplane Board Removal
1
1
drive carrier
3
SAS/SATA backplane board
5
optical drive power connector
7
securing tabs (7)
Installing the SAS/SATA Backplane Board
1 Position the SAS/SATA backplane board so that the securing tabs on the
chassis are fully inserted into the securing slots on the backplane board.
See Figure 3-30.
2 Pull and hold the release pin, and then tilt the backplane board toward the
front of the system until it stops, then release the release pin and ensure
that it snaps into place.
3 Reinstall the sideplane board. See "Installing the Sideplane Board" on
page 127.
130
Installing System Components
2
2
SAS backplane board release pin
4
power cable from system board
6
securing slots (7)
4
3
5
6
7