Figure 3-19. Removing and Replacing the Riser 2 Board
1
expansion-card bracket
3
Phillips screw
5
tab hook (4)
5 Remove the expansion-card riser board:
Using a Phillips screwdriver, remove the securing screw from the
a
assembly. See Figure 3-19.
Slide the riser board off of the four securing tab hooks.
b
Lift the riser board from the bracket.
c
Replacing the Riser 2 Board on the Expansion-Card Bracket
1 Place the riser board in the expansion-card bracket so that the four tab
hooks are fully inserted through the tab slots on the riser board. See
Figure 3-19.
2 Slide the riser board into the tab hooks.
5
2
4
Installing System Components
1
4
riser 2 board
tab slot (4)
2
3
103