Removing And Installing Front Brake Discs; Removing And Installing Rear Brake Disc - BMW R1150RT - MAINTENANCE INTEGRAL ABS Maintenance Manual

Removing and installing front
34 11
brake discs
d
Warning:
When removing and installing the brake calipers,
force back the pistons carefully to ensure that the
wheel-circuit reservoir does not overflow.
If fluid escapes, proceed in accordance with "in-
structions for filling reservoir" (
•
Remove the brake calipers.
•
Remove front wheel.
1
3
L
Note:
Retaining screws (1) are secured with thread-lock-
ing compound and should be heated if necessary
before removal.
•
Remove brake discs.
e
Attention:
Note thrust washers between right brake disc and
front wheel, and note ABS sensor ring between left
brake disc and front wheel.
•
Install ABS sensor ring (2) on left and thrust
washers (3) on right beneath brake disc.
•
Degrease brake discs before installing.
e
Attention:
Install brake discs right way round (inscriptions on
brake discs facing toward the outside).
X
Tightening torque:
Brake disc to front wheel
(clean thread + Loctite 2701)....................... 21 Nm
34.8
34 21
brake disc
d
When removing and installing the brake caliper,
force back the pistons carefully to ensure that the
wheel-circuit reservoir does not overflow.
If fluid escapes, proceed in accordance with "in-
34.25). structions for filling reservoir" (
a
•
•
2
1
R28340150
L
Retaining screws (1) are secured with thread-lock-
ing compound and should be heated if necessary
before removal.
•
•
•
e
Make sure the spacer is fitted when the rear wheel
is installed.
X
Brake disc to rear wheel drive
(clean thread + Loctite 2701)....................... 21 Nm
Removing and installing rear
Warning:
Remove the brake caliper.
Remove rear wheel.
1
Note:
Remove brake disc.
Installation is the reverse of the removal proce-
dure.
Degrease the brake disc before installing.
Attention:
Tightening torque:
34.28).
a
R28340130