Continuous - Minolta DYNAX 7 User Manual

CONTINUOUS

This camera has both single-frame and continuous advance drive
modes. Select single-frame advance to expose and advance the
film one frame at a time. Switch to continuous drive to photograph
dynamic action sequences at up to 4 frames per second in high
speed mode (3.7 when AF-A or AF-C is selected) or 2 frames per
second in low speed mode.
1. Turn the drive-mode lever to the
desired drive mode.
If continuous advance is selected...
2. Open the control-panel door,
then press the adjust button.
3. Turn either control dial to
select high or low speed con-
tinuous drive.
88
- Single-Frame Advance
- Continuous Advance
• The display will switch to the
setting display.
• Press the shutter-release button partway down
to enter the setting.
tinuous,
mode.
4. Keep pressing the shutter-release button to take the pic-
tures.
• The high or low setting will remain selected until you change it.
• When the built-in flash is up or an accessory flash is on, the shutter
can not be released until the flash is charged.
• The shutter can not be released until the camera has focused on your
subject.
• If AF-S (Single-shot autofocus) is selected, focus will be locked until
the series of continuous frames is finished.
• Return the drive-mode lever to
mode.
• AF Zoom xi and Power zoom lenses cannot be zoomed when
continuous-advance mode is selected.
• When the battery power is low or in low temperatures, the maxi-
mum drive speed may temporarily drop. Continued operation with
low battery power may even cause a complete stoppage.
HI remains for high con-
LO remains for low continuous
to cancel the continuous drive
89