Minolta DYNAX 7 User Manual page 97

TROUBLE SHOOTING (DISPLAY)
Display Cause
When full-auto
one of the memory
positions is selected,
the position of the
controls may not
match the camera
Upper part of display
settings.
turns black
Scene or subject
brightness is beyond
the camera's meter-
ing range.
blinks.
Light level is beyond
the range of avail-
able shutter speeds
and apertures.
Shutter speed and
aperture turns black
or blinks.
The required shutter
speed is beyond the
range of the camera
(A mode only)
Shutter speed turns
black or blinks.
192
Solution
or
Take picture using
the information pre-
sented in the navi-
gation display.
Bright Light
Use slower speed
film, a neutral density
(ND) filter, or reduce
the light level of your
surroundings.
Low Light
Use higher speed
film or a flash.
Select a larger or
smaller aperture
until the display
returns to normal.
Display Cause
The required aper-
ture is beyond the
range of the lens.
(S mode only)
Aperture turns black
or blinks.
This indicates that a multiple exposure is
about to be made. Either multiple exposure
has been selected by the drive mode
lever, or the film has been partially rewound
using the select-frame film transport function.
Frame counter turns
black
A combination of causes has occurred.
Remove and reinstall the batteries. If nor-
mal camera operation does not resume or
the camera malfunctions repeatedly, contact
an authorized Minolta Service Facility.
Solution
Select a faster or
slower shutter speed
until the display
returns to normal.
193