Minolta DYNAX 7 User Manual page 88

CUSTOM 19, 20
3. Exposure compensation using rear control dial (P
ter speed in P mode)
In P/A/S mode, exposure compensation is possible using the rear
control dial.
• If you turn the front control dial in P mode, you can select the shutter
speed.
Control Dial Tasking
Exposure
Mode Front Control Dial
P - Mode P - shutter speed
S
A - Mode Aperture
S - Mode Shutter speed
• Exposure compensation, using the rear control dial, is the same as for
setting 2. Please refer to the notes in setting 2.
Custom 19 - Control Dial - Exchanged Control
This custom function allows you to switch the operations of the front
and read control dials.
1. Unchanged from Custom 18.
2. Front and rear control dial functions
exchanged.
• Control dial tasking does not change for brack-
eting, data memory, and custom functions.
174
- shut-
S
Rear Control Dial
Exposure
compensation
To set custom functions;
1.Open control-panel door and press the CUSTOM button.
2.Turn the front control dial to select the desired custom function.
3.Turn the rear control dial to seclect the setting.
4.Press the shutter-release button partway down to enter the setings.
Refer to pages 154-157 for additional information.
Custom 20 - Flash Metering
Your camera uses ADI flash metering as the
standard flash metering mode, but it can be
changed.
• This applies to both the built-in and accessory
flash.
• When full auto is selected, if possible, flash
metering is always ADI, even if Custom 20-2/3
is selected. If not possible, due to a flash/lens
combination, TTL 4-segment flash will be used.
1. ADI 4-segment
When flash fires, ADI 4-segment or pre-flash metering will be used.
• For more information see page 108.
2. TTL 4-segment
When flash fires, TTL 4-segment metering will be used.
• Recommend TTL 4-segment metering if using a flash/color meter,
close-up diffuser, or filter.
3. TTL Average
When flash fires, TTL average metering will be used.
4-segment metering
175