Clearing Logins; Displaying Fcoe Configuration-Related Information; Managing And Displaying The Fcoe Login Configuration; Enabling Or Disabling Fcoe Login Configuration Management - Dell 53-1002116-01 Administrator's Manual

To configure FIP multicast advertisement intervals, perform the following task.
Task
Configure FIP multicast advertisement intervals.
Syntax is as follows:
•

Clearing logins

To clear logins, perform the following task.
Task
Clear the logins that occurred through a front-end
port or from a device specified by the Enode's
VN_port WWN. Syntax is as follows:
•
•

Displaying FCoE configuration-related information

To display FCoE-related configuration information, perform the following tasks.
Task
Display the embedded FCoE port configuration.
Configurations of all the ports are displayed if you
do not specify a specific port.
Display information about devices logged into a
specific FCoE F_port.
Display FIP configurations.

Managing and displaying the FCoE login configuration

Another important task in administrating FCoE is configuring the FCoE login information.
Enabling or disabling FCoE login
configuration management
The fcoelogincfg command allows only configured ENode VN_ports to log in. Use the
fcoelogingroup command to configure allowed ENode VN_ports. The default is disabled.
Disabling the fcoelogincfg command allows unrestricted login on ENode VN_ports.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
intvl—Specifies the interval in seconds. The
minimum interval value is 0 seconds and
the maximum value is 300 seconds. A value
of 0 cancels the previous advertisement
interval value.
-teport slot/port—Specifies the slot or port
number.
-device wwn—Specifies the device WWN.
Managing and displaying the FCoE login configuration
Command
switch:admin> fcoe --fipcfg -advintvl intvl
Command
switch:admin> fcoe --resetlogin -teport slot/port |
-device wwn
Command
switch:admin> fcoe --cfgshow [port]
switch:admin> fcoe --loginshow [port]
switch:admin> fcoe --fipcfgshow
16
133