Table of Contents
Advertisement
2. Configure the source port and the destination port, with the both parameter for all packets.
3. Optional: Use the description command to add a label to the monitor session.
4. Repeat
Deleting a Port Mirroring connection from a session
To remove a single connection from a Port Mirroring session, perform the following steps in global
configuration mode.
1. Display the existing configuration of the monitor session.
2. Open an existing monitor session.
3. Use the no option to delete a particular port connection.
4. Display the monitor session again to confirm the connection deletion.
5. Repeat
Deleting a Port Mirroring session
To remove a Port Mirroring session, perform the following steps in global configuration mode.
1. Display the existing configuration of the monitor session.
2. Enter global configuration mode with the enable command.
3. Delete the existing monitor session using the no option.
4. Return to Privileged EXEC mode with the exit command.
5. Display the monitor session again to confirm the connection deletion.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction both
switch(config-mon-sess-1)#description Hello World!
step 1
and
step 2
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
switch#show monitor session 1
switch(config)#monitor session 1
switch(config-mon-sess-1)#no source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction both
switch#show monitor session 1
step 2
and
step 3
A monitor session can have only one port.
switch#show monitor session 1
switch(config)#no monitor session 1
switch#show monitor session 1
Deleting a Port Mirroring connection from a session
as needed for additional ports.
as needed for additional ports.
13
121
Advertisement
Table of Contents
