Configuring Interface Tracking; Clearing Lacp Counter Statistics On A Lag - Dell 53-1002116-01 Administrator's Manual

2. Enter the port-channel sub-mode.
3. Configure the minimum links.

Configuring interface tracking

The track interface command lets you track one or more external ports on your switch. Only
external physical interfaces and port-channel interfaces can be tracked. The show output for
internal interfaces is enhanced to include the information of which external interfaces are being
tracked. Additionally, there is a command provided to enable (or disable) the tracking under
internal interface sub-mode. This command is track enable. External interfaces can be tracked only
if tracking is enabled by means of this command.
The semantics of track interface are as follows:
•
•
•
•
•
•
•
In the following procedure, tracking is enabled and the internal interface 0/8 is tracking external
interfaces 0/15,0/16, and 0/17. Perform the following steps from global configuration mode.
1. Select the internal interface to use as the tracking monitor.
2. Enable tracking.
3. Select one or more external interfaces to be tracked.

Clearing LACP counter statistics on a LAG

To clear LACP counter statistics, perform the following task from Privileged EXEC mode.
1. Enter the clear command to clear the LACP counter statistics for the specified LAG group
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
switch(conf-if-te-0/1)#interface port-channel 63
switch(conf-if-po-63)#minimum-links 3
One internal interface can track one or more external interfaces.
Multiple internal interfaces can track the same external interface.
If multiple external interfaces are being tracked by one internal interface, only if all of them go
DOWN, the internal interface should go DOWN.
Only the operational status of the external interface is tracked – not the admin state.
If multiple internal interfaces are tracking a single external interface and if the external
interface goes DOWN, all those internal interfaces should go DOWN.
A maximum of eight external interfaces can be tracked from an internal interface.
Forward referenced port-channels (non-existing port-channels) are tracked.
switch(config)#interface intengigabitethernet 0/8
switch(conf-if-int-0/8)#track enable
switch(conf-if-int-0/8)#track interface extengigabitethernet 0/15
switch(conf-if-int-0/8)#track interface extengigabitethernet 0/16
switch(conf-if-int-0/8)#track interface extengigabitethernet 0/17
number.
switch#clear lacp 42 counters
LACP configuration and management
7
71