Applying A Mac Acl To A Cee Interface; Applying A Mac Acl To A Vlan Interface - Dell 53-1002116-01 Administrator's Manual

To reorder the rules in a MAC ACL, perform the following task from Privileged EXEC mode.
1. Enter the resequence command to assign sequence numbers to the rules contained in the

Applying a MAC ACL to a CEE interface

Ensure that the ACL that you want to apply exists and is configured to filter traffic in the manner
that you need for this CEE interface. An ACL does not take effect until it is expressly applied to an
interface using the access-group command. Frames can be filtered as they enter an interface
(ingress direction).
To apply a MAC ACL to a CEE interface, perform the following steps from Privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the switchport command to configure the interface as a Layer 2 switch port.
4. Enter the mac-access-group command to specify the MAC ACL that is to be applied to the Layer

Applying a MAC ACL to a VLAN interface

Ensure that the ACL that you want to apply exists and is configured to filter traffic in the manner
that you need for this VLAN interface. An ACL does not take effect until it is expressly applied to an
interface using the access-group command. Frames can be filtered as they enter an interface
(ingress direction).
To apply a MAC ACL to a VLAN interface, perform the following steps from Privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to apply the VLAN interface to the MAC ACL.
3. Enter the mac-access-group command to specify the MAC ACL that is to be applied to the VLAN
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
MAC ACL.
switch#resequence access-list mac test_02 50 5
switch(config)#interface intengigabitethernet 0/1
2 CEE interface in the ingress direction.
switch(conf-if-te-0/1)#mac access-group test_02 in
switch(config)#interface vlan 50
interface in the ingress direction.
switch(conf-if-vl-82)# mac access-group test_02 in
ACL configuration and management
9
91