Table of Contents
Advertisement
13
Configuring ingress Port Mirroring
Configuring ingress Port Mirroring
To configure Port Mirroring for incoming packets only, perform the following steps in global
configuration mode.
1. Open a monitor session and assign a session number
2. Configure the source port and the destination port, with the rx parameter for received packets.
3. Optional: Use the description command to add a label to the monitor session.
4. Repeat
Configuring egress Port Mirroring
To configure Port Mirroring for incoming packets only, perform the following steps in global
configuration mode.
1. Open a monitor session and assign a session number
2. Configure the source port and the destination port, with the tx parameter for transmitted
3. Optional: Use the description command to add a label to the monitor session.
4. Repeat
Configuring bidirectional Port Mirroring
To configure Port Mirroring for packets traveling in both directions, perform the following steps in
global configuration mode.
1. Open a monitor session and assign a session number
120
switch(config)# monitor session 1
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction rx
switch(config-mon-sess-1)#description Hello World!
step 1
and
step 2
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
switch(config)# monitor session 1
packets.
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction tx
switch(config-mon-sess-1)#description Hello World!
step 1
and
step 2
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
switch(config)# monitor session 1
as needed for additional ports.
as needed for additional ports.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
Advertisement
Table of Contents
