Table of Contents
Advertisement
6
Configuring STP, RSTP, or MSTP on CEE interface ports
Guard root protects the root bridge from malicious attacks and unintentional misconfigurations
where a bridge device that is not intended to be the root bridge becomes the root bridge. This
causes severe bottlenecks in the data path. Guard root ensures that the port on which it is enabled
is a designated port. If the guard root-enabled port receives a superior BPDU, it goes to a
discarding state.
To enable the guard root on a CEE interface, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the spanning-tree command to enable the guard root on a CEE interface.
Specifying the MSTP hello time
From the CEE interface, use this command to set the time interval between BPDUs sent by the root
switch. Changing the hello-time affects all spanning tree instances.
The max-age setting must be greater than the hello-time setting (see
maximum aging time"
To specify the MSTP hello time on a CEE interface, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the spanning-tree command to specify the hello time on a CEE interface.
Specifying restrictions for an MSTP instance
From the CEE interface, use this command to specify restrictions on the interface for an MSTP
instance.
To specify restrictions for an MSTP instance on a CEE interface, perform the following steps.
1. Enter the configure terminal command to access global configuration mode from Privileged
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
60
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#spanning-tree guard root
on page 53). The range is 1 through 10 seconds. The default is 2 seconds.
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#spanning-tree hello-time 5
EXEC mode.
switch(config)#interface intengigabitethernet 0/1
"Specifying the bridge
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
Advertisement
Table of Contents
