Figure 3-109 Port Priority Configuration - SMC Networks 8126PL2-F - annexe 1 Management Manual

3
Configuring the Switch
Command Attributes
• Default Priority
the specified interface. (Range: 0-7; Default: 0)
• Number of Egress Traffic Classes – The number of queue buffers provided for
each port.
Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
Information of Eth 1/3
Broadcast Threshold:
Multicast Threshold:
Unknown Unicast Threshold:
LACP Status:
Ingress Rate Limit:
Egress Rate Limit:
VLAN Membership Mode:
Ingress Rule:
Acceptable Frame Type:
Native VLAN:
Priority for Untagged Traffic: 5
GVRP Status:
Allowed VLAN:
Forbidden VLAN:
Private-VLAN Mode:
Private-VLAN host-association: NONE
Private-VLAN Mapping:
802.1Q-tunnel Status:
802.1Q-tunnel Mode:
802.1Q-tunnel TPID:
Console#
14. CLI displays this information as "Priority for untagged traffic."
3-190
14
– The priority that is assigned to untagged frames received on

Figure 3-109 Port Priority Configuration

Enabled, 500 packets/second
Disabled
Disabled
Disabled
Disabled, 1000 Mbits per second
Disabled, 1000 Mbits per second
Hybrid
Disabled
All frames
1
Disabled
NONE
NONE
Disable
NORMAL
8100(Hex)
1(u),
4-155
4-245
4-165