Dot1X Timeout Tx-Period; Dot1X Timeout Supp-Timeout - SMC Networks 8126PL2-F - annexe 1 Management Manual

dot1x timeout tx-period

This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no form to
reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#

dot1x timeout supp-timeout

This command sets the time that an interface on the switch waits for a response to
an EAP request from a client before re-transmitting an EAP packet. Use the no form
to reset to the default value.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Command Usage
This command sets the timeout for EAP-request frames other than
EAP-request/identity frames. If dot1x authentication is enabled on a port, the
switch will initiate authentication when the port link state comes up. It will send
an EAP-request/identity frame to the client to request its identity, followed by
one or more requests for authentication information. It may also send other
EAP-request frames to the client during an active connection as required for
reauthentication.
Authentication Commands
4
4-117