Figure 3-139 Cluster Configuration - SMC Networks 8126PL2-F - annexe 1 Management Manual

• Cluster IP Pool – An "internal" IP address pool that is used to assign IP addresses
to Member switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 16. Note that you cannot change the
cluster IP pool when the switch is currently in Commander mode. Commander
mode must first be disabled.
• Number of Members – The current number of Member switches in the cluster.
• Number of Candidates – The current number of Candidate switches discovered
in the network that are available to become Members.
Web – Click Cluster, Configuration.
CLI – This example first enables clustering on the switch, sets the switch as the
cluster Commander, and then configures the cluster IP pool.
Console(config)#cluster
Console(config)#cluster commander
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#exit
Console#show cluster
Role:
Interval heartbeat:
Heartbeat loss count: 3
Number of Members:
Number of Candidates: 2
Console#

Figure 3-139 Cluster Configuration

commander
30
1
3
Switch Clustering
4-56
4-57
4-58
4-59
3-237