Mapping Cos Values To Egress Queues; Figure 3-82. Port Priority Configuration - SMC Networks 6152L2 - annexe 1 Management Manual

Web – Click Priority, Default Port Priority or Default Trunk Priority.
Modify the default priority for any interface, then click Apply.
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
Information of Eth 1/3
Broadcast threshold:
LACP status:
Ingress rate limit: enable, K bits per second: 25
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 5
GVRP status:
Allowed VLAN:
Forbidden VLAN:
Private-VLAN mode:
Private-VLAN host-association: NONE
Private-VLAN mapping:
Console#

Mapping CoS Values to Egress Queues

This switch processes Class of Service (CoS) priority tagged traffic by
using eight priority queues for each port, with service schedules based on
strict or Weighted Round Robin (WRR). Up to eight separate traffic

Figure 3-82. Port Priority Configuration

C S
LASS OF ERVICE
Enabled, 500 packets/second
Disabled
Hybrid
Enabled
All frames
1
Disabled
1(u),
NONE
NONE
C
ONFIGURATION
4-146
4-222
4-156
3-187