SMC Networks 7904WBRA4 - annexe 1 Manual page 49

The following table describes the parameters of this page.
Field
Current ATM VC Table
VPI
VCI
Encapsulation
Channel Mode
Admin Status
Enable NAPT
Login Name
Password
Connection Type
Idle Time(min)
WAN IP Settings
Type
This table shows the existed PVCs. It shows the Interface name, channel mode,
VPI/VCI, encapsulation mode, local IP address, remote IP address and other
information. The maximum item of this table is eight.
Click it, the IP Interface-Modify page appears. You can modify the PVCs'
parameters.
The virtual path between two points in an ATM network, ranging from 0 to
255.
The virtual channel between two points in an ATM network, ranging from 32
to 65535 (1 to 31 are reserved for known protocols)
You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA, or 1483 Routed.
Select Disable, this PVC is unusable.
Select it to enable the NAPT function of the router. If you do not select it and
you want to access the Internet normally, you must add a router on the uplink
equipment. Otherwise, the access to the Internet fails. Normally, it is required
to enable NAPT.
The correct user name that your ISP has provided to you.
The correct password that your ISP has provided to you.
You can choose Continuous, Connect on Demand, or Manual.
If select connect on demand, you need to enter the idle timeout time. Within
the preset minutes, if the router does not detect the flow of the user
continuously, the router automatically disconnects the PPPoE connection.
You can choose Fixed IP or Use DHCP.
If select Fixed IP, you should enter the local IP address, remote IP address
and subnet mask.
32
Description