SMC Networks 7904WBRA4 - annexe 1 Manual page 27

VPI
VCI
Before you configure the protocol, you must select the country in which you are in and your ISP.
PPPoE
If the uplink equipment supports the PPPoE protocol, you can set the device to initiate the PPPoE dialup.
After finishing the settings, click NEXT. The page shown in the following figure appears.
If you ensure the configuration is correct, click FINISH. Then the configuration takes effect. You can check the
configuration in the WAN page.
You can choose LLC or VC-Mux.
The virtual path between two points in an ATM network, and its valid value is
from 0 to 255.
The virtual channel between two points in an ATM network, ranging from 32 to
65535 (0 to 31 is reserved for local management of ATM traffic).
10