Radius Client; Table 4-29 Radius Client Commands - SMC Networks 6824MPE INT Management Manual

C L
OMMAND INE
• You can specify three authentication methods in a single command to
indicate the authentication sequence. For example, if you enter
"authentication enable radius tacacs local," the user name and
password on the RADIUS server is verified first. If the RADIUS server
is not available, then authentication is attempted on the TACACS+
server. If the TACACS+ server is not available, the local user name and
password is checked.
Example
Console(config)#authentication enable radius
Console(config)#
Related Commands
enable password (4-38)

RADIUS Client

Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access to RADIUS-aware devices on the network. An authentication
server contains a database of multiple user name/password pairs with
associated privilege levels for each user or group that require management
access to a switch.
Command
radius-server host
radius-server port
radius-server key
radius-server retransmit Sets the number of retries
radius-server timeout
show radius-server
4-102
I
NTERFACE

Table 4-29 RADIUS Client Commands

Function
Specifies the RADIUS server
Sets the RADIUS server network port
Sets the RADIUS encryption key
Sets the interval between sending
authentication requests
Shows the current RADIUS settings
Mode Page
GC 4-103
GC 4-104
GC 4-104
GC 4-105
GC 4-105
PE 4-106