Table of Contents
Advertisement
CLI - This example sets a default domain name and a domain list.
However, remember that if a domain list is specified, the default domain
name is not used.
Console(config)#ip domain-name sample.com
Console(config)#ip domain-list sample.com.uk
Console(config)#ip domain-list sample.com.jp
Console(config)#ip name-server 192.168.1.55 10.1.0.55
Console(config)#ip domain-lookup
Console#show dns
Domain Lookup Status:
DNS enabled
Default Domain Name:
.sample.com
Domain Name List:
.sample.com.uk
.sample.com.jp
Name Server List:
192.168.1.55
10.1.0.55
Console#
Configuring Static DNS Host to Address Entries
You can manually configure static entries in the DNS table that are used to
map domain names to IP addresses.
Command Usage
•
Static entries may be used for local devices connected directly to the
attached network, or for commonly used resources located elsewhere
on the network.
•
Servers or other network devices may support one or more
connections via multiple IP addresses. If more than one IP address is
associated with a host name in the static table or via information
returned from a name server, a DNS client can try each address in
succession, until it establishes a connection with the target device.
Command Attributes
•
Host Name – Name of a host device that is mapped to one or more
IP addresses. (Range: 1-64 characters)
C
D
ONFIGURING
N
S
OMAIN
AME
ERVICE
4-280
4-281
4-282
4-283
4-285
3-209
Advertisement
Table of Contents
