Removable Control Panel; Inserting And Removing Cds; Switching On/ Off - VDO MS 4400 Manual

Removable control panel

Removing the control panel
1. Open the front by pressing the REL button.
2. Press the control panel carefully to the left and pull it out of the holder to the right.
Re-inserting control panel
1. Place the control panel, while folded down, on the mounting tab to the right of the
unit.
2. Snap the control unit into the mounting tab at the bottom left of the unit.
3. Check that both mounting tabs are snapped into place and close the control panel.

Inserting and removing CDs

Inserting a CD
1. Open the front panel.
2. Insert the CD into the drive (printed side up).
For audio/ MP3 CDs, playback starts automatically.
3. Close the front panel.
Removing a CD
1. Open the front panel.
2. Press the e button and carefully remove the CD.
3. Close the front panel.

Switching on/ off

Press the POWER button to switch the unit on or off.
Switching on and off with the ignition key
If the unit is switched on, it can be switched off and on automatically by removing or
inserting and turning the ignition key.
Automatic switch off
If the unit was turned on using the POWER button with the ignition off, it automati-
cally switches itself off after a set time.
The time for the automatic switch off can be configured in the setup menu, see
page 43.
Operation
11