Mounting; Metal Sleeve (Fig. F And G ); Connecting The Radio (Fig. C); Mounting The Radio (Fig. G And H) - VDO CD 1327 User Manual

Connecting 4 loudspeakers
Side & pol. Front/colour Pin
Left (+) Green [B5]
Left (-) Green/black [B6]
Right (+) Grey [B3]
Right (-) Grey/black [B4]
1 ) For this accessory, contact your dealer.
Line out
You can connect a power amplifier with 2 or 4
additional loudspeakers to this set using the
labelled RCA cable.
Red socket to right channel
White socket to left channel.
Audio In
You can connect external audio equipment via
the labelled AUX-in RCA cables.
Red wire for Right Channel input
White wire for Left Channel input.

MOUNTING

Metal Sleeve (fig. F and G )

Install the metal sleeve in the dashboard. For
optimal performance of the CD player, the metal
sleeve should be positioned horizontally (be-
tween -10° and +30°).
Fix metal sleeve into place by pressing the metal
tags outwards using a screwdriver.

Connecting the Radio (fig. C)

Ensure the battery is disconnected.
Insert power supply connector A' into socket
A.
Insert loudspeaker connector B' into socket
B.
(Optional) Insert the line-out connector into
the corresponding socket.
(Optional) Insert the AUX connector into the
corresponding socket.
Insert aerial plug into the aerial socket (good
reception is only possible with a good aerial).
If an antenna adaptor is needed, please con-
sult your dealer.

Mounting the Radio (fig. G and H)

This radio can be properly installed either from
conventional Front Mounting and/or from Rear
Mounting.
Front Mounting
Slide the radio into the metal sleeve until the
springs at either side of the radio snap into
the openings of the sleeve.
Finally reconnect the negative car battery
terminal.
Rear Mounting
Rear/colour Pin Choose a position where the screw holes of
White [B7]
the mounting bracket and the screw holes of
White/black [B8]
the radio become aligned and tighten the
Blue [B1]
screws at 2 places on each side.
Blue/black [B2]
Only use M5 screws that are not longer than
6 mm.
Removing the Radio (using the two
removal keys supplied) (fig. J)
Press the REL button and open the front
panel.
Insert both removal keys into the holes on the
front of the set until they lock.
Pull out the radio.

Replacing the Fuse (fig. C)

Replace with a 15A blade-type fuse.
The new fuse must be of exactly this value
and type otherwise the set will not be ad-
equately protected. Ignoring this procedure
may lead to damage to the set, which will
invalidate the guarantee.

Interference Suppression

Most modern cars have sufficient interference
suppression. If you experience interference
generated by the car, consult your dealer.
FRONT PANEL AND REMOTE
CONTROL
See fig. A and E.

Front Panel and Remote Control

Function(s)
1.
2.
3.
1. Switch On / Off the set
Press to fold down the front
panel
11. Radio:
Short press: auto-seek a
station (auto mode)/stop
the frequency (manual
mode)
Long press: activate
manual tuning mode
CD:
Short press: select the
previous or next track/
file
Long press: Review/
Fast-forward the current
track
13