APRILIA SCARABEO 50 - 1997 Manual page 44

Carefully read p. 33 (MAINTENANCE).

Upon disassembly, take care not
to damage the brake pipe, disc
and pads.
Position the vehicle on the centre stand.
Unscrew and remove the two screws (1).
Brake caliper screw driving torque:
27 Nm (2.7 kgm).
44 use and maintenance Scarabeo 50

Never pull the rear brake lever
after removing the brake caliper,
otherwise the caliper pistons
may go out of their seats, thus causing
the outflow of the brake fluid.
In this case consult your
Dealer, who will carry out the proper
maintenance operation.
Remove the brake caliper (2), by careful-
ly withdrawing it from the brake disc.

After reassembly, pull the rear
b r a k e l e ve r r e p ea t e d l y a n d
check the correct functioning of
the braking system.
Carefully read p. 33 (MAINTENANCE).
Official Position the vehicle on the centre stand.
Lift the protection element (3).

Support the rear-view mirror (4),
to prevent it from accidentally
falling down.
Keep the screw (5) locked and loosen
the nut (6) completely.
Remove the rear-view mirror (4).