Dell POWEREDGE 1950 Hardware Owner's Manual page 27

Table 1-8. System Messages (continued)
Message
General failure
Invalid NVRAM
configuration, Resource
Re-allocated
Keyboard Controller
failure
Manufacturing mode
detected
MEMBIST failure - The
following DIMM/rank has
been disabled by BIOS:
DIMM x Rank y
Memory address line
failure at address, read
value expecting value
Memory double word logic
failure at address, read
value expecting value
Memory odd/even logic
failure at address, read
value expecting value
Memory write/read failure
at address, read value
expecting value
Memory tests terminated by
keystroke.
No boot device available
Causes
The operating system is unable to carry
out the command.
System detected and corrected a
resource conflict.
Faulty keyboard controller; faulty
system board
System is in manufacturing mode.
Faulty memory module(s).
Faulty or improperly installed memory
modules.
POST memory test terminated by
pressing the spacebar.
Faulty or missing optical drive
subsystem, hard drive, or hard-drive
subsystem, or no boot disk in drive A.
Corrective Actions
This message is usually followed by
specific information. Note the
information, and take the appropriate
action to resolve the problem.
No action is required.
See "Getting Help" on page 125.
Reboot to take the system out of
manufacturing mode.
See "Troubleshooting System Memory"
on page 102.
See "Troubleshooting System Memory"
on page 102.
Information only.
Use a CD or hard drive. If the problem
persists, see "Troubleshooting an Optical
Drive" on page 103 and "Troubleshooting
a Hard Drive" on page 104. See "Using
the System Setup Program" on page 31
for information on setting the order of
boot devices.
About Your System
27