Dell POWEREDGE 1950 Hardware Owner's Manual page 18

Table 1-7. LCD Status Messages (continued)
Code Text
E1211 ROMB Batt
E1229 CPU # VCORE
E1310 RPM Fan ##
E1311 RPM Fan Mod #x
E1313 Fan Redundancy
E1410 CPU # IERR
E1414 CPU # Thermtrip
18
About Your System
Causes
RAID battery is either missing,
bad, or unable to recharge due to
thermal issues.
Processor # VCORE voltage
regulator has failed.
RPM of specified cooling fan is
out of acceptable operating range.
RPM of fan x in the # module is
out of acceptable operating range.
The system is no longer fan-
redundant. Another fan failure will
put the system at risk of over-
heating.
Specified microprocessor is
reporting an internal error.
Specified microprocessor is out of
acceptable temperature range and
has halted operation.
Corrective Actions
Reseat the RAID battery
connector. See "RAID Battery" on
page 60, and "Troubleshooting
System Cooling Problems" on
page 101.
See "Getting Help" on page 125.
See "Troubleshooting System
Cooling Problems" on page 101.
See "Troubleshooting System
Cooling Problems" on page 101.
Check control panel LCD for
additional scrolling messages. See
"Troubleshooting System Cooling
Problems" on page 101.
See your system's "Information
Update Tech Sheet" located on
support.dell.com for the most
current system information. If the
problem persists, see "Getting
Help" on page 125.
See "Troubleshooting System
Cooling Problems" on page 101. If
the problem persists, ensure that
the microprocessor heat sinks are
properly installed. See
"Troubleshooting the
Microprocessors" on page 108.
NOTE:
The LCD continues to
display this message until the
system's power cord is
disconnected and reconnected to
the AC power source, or the SEL
is cleared using either Server
Assistant or the BMC
Management Utility. See the Dell
OpenManage Baseboard
Management Controller User's
Guide for information about these
utilities.