Dell POWEREDGE 1950 Hardware Owner's Manual page 21

Table 1-7. LCD Status Messages (continued)
Code Text
HDD ## Rbld Abrt The specified hard drive has
E1811
E1812 HDD ## Removed
E1913 CPU & Firmware
Mismatch
E1A14 SAS Cable A
E1A15 SAS Cable B
E1A17 Pwr Cable FB
E1A18 PDB Ctrl Cable
E2010 No Memory
E2011 Mem Config Err
E2012 Unusable Memory
Shadow BIOS Fail The system BIOS failed to copy its
E2013
E2014 CMOS Fail
E2015 DMA Controller
Causes
experienced a rebuild abort.
The specified hard drive has been
removed from the system.
The BMC firmware does not
support the CPU.
SAS cable A is missing or bad.
SAS cable B is missing or bad.
Flex bay power cable is missing or
bad.
Flex bay control signals cable is
missing or bad.
No memory is installed in the
system.
Memory detected, but is not
configurable. Error detected
during memory configuration.
Memory is configured, but not
usable. Memory subsystem failure.
flash image into memory.
CMOS failure. CMOS RAM not
functioning properly.
DMA controller failure.
Corrective Actions
See "Troubleshooting a Hard
Drive" on page 104. If the problem
persists, see your RAID
documentation.
Information only.
Update to the latest BMC
firmware. See the BMC User's
Guide for more information on
setup and use of BMC.
Reseat the cable. If the problem
persists, replace the cable. See
"SAS Controller Daughter Card"
on page 56.
Reseat the cable. If the problem
persists, replace the cable. See
"SAS Controller Daughter Card"
on page 56.
Reseat the cable. If the problem
persists, replace the cable. See
"SAS Controller Daughter Card"
on page 56.
Reseat the cable. If the problem
persists, replace the cable. See
"SAS Controller Daughter Card"
on page 56.
Install memory. See "Installing
Memory Modules" on page 65.
See "Troubleshooting System
Memory" on page 102.
See "Troubleshooting System
Memory" on page 102.
See "Troubleshooting System
Memory" on page 102.
See "Getting Help" on page 125.
See "Getting Help" on page 125.
About Your System
21