Entering The Password; Accessing The Smt Via Telnet; Figure 69 Initial Screen - ZyXEL Communications ZYAIR G-5100 User Manual

ZyAIR G-5100 User's Guide

Figure 69 Initial Screen

12.2.2 Entering the Password

The login screen appears after you press [ENTER], prompting you to enter the password, as
shown below.
For your first login, enter the default password "1234". As you type the password, the screen
displays an "X" for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your ZyAIR
will automatically log you out and display a blank screen. If you see a blank screen, press
[ENTER] to bring up the login screen again.
Password Screen

12.3 Accessing the SMT via Telnet

The following procedure details how to telnet into your ZyAIR.
1 In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.2" (the default IP address) and click OK.
2 For your first login, enter the default password "1234". As you type the password, the
screen displays an asterisk "*" for each character you type.
139
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =1, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =2, ethernet address: 00:00:00:00:00:00
initialize ch =3, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =4, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =5, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =6, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =7, ethernet address: 00:A0:C5:62:B0:E3
initialize ch =8, ethernet address: 00:00:00:00:00:00
initialize ch =9, ethernet address: 00:00:00:00:00:00
initialize ch =10, ethernet address: 00:00:00:00:00:00
initialize ch =11, ethernet address: 00:00:00:00:00:00
initialize ch =12, ethernet address: 00:00:00:00:00:00
Press ENTER to continue...
Enter Password : XXXX
Chapter 12 Introducing the SMT