Configuring Password; Figure 33 Password; Table 6 Password - ZyXEL Communications NWA-3100 User Manual

Chapter 4 System Screens
Table 5 System General Setup
LABEL
First DNS Server
Second DNS Server
Third DNS Server
Apply
Reset

4.3 Configuring Password

It is strongly recommended that you change your ZyXEL Device's password. Click SYSTEM
> Password. The screen appears as shown.
If you forget your ZyXEL Device's password (or IP address), you will need to reset the device.
See the section on resetting the ZyXEL Device for details

Figure 33 Password.

The following table describes the labels in this screen.

Table 6 Password

LABEL
Old Password
New Password
Retype to Confirm
Apply
Reset
64
DESCRIPTION
Select From DHCP if your DHCP server dynamically assigns DNS server
ZyXEL Device
information (and the
right displays the (read-only) DNS server IP address that the DHCP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined,
but leave the IP address set to 0.0.0.0, User-Defined changes to None after
you click Apply. If you set a second choice to User-Defined, and enter the
same IP address, the second User-Defined changes to None after you click
Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a machine in order
to access it.
The default setting is None.
Click Apply to save your changes.
Click Reset to reload the previous configuration for this screen.
DESCRIPTIONS
Type in your existing system password (1234 is the default password).
Type your new system password (up to 31 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Retype your new system password for confirmation.
Click Apply to save your changes.
Click Reset to reload the previous configuration for this screen.
's Ethernet IP address). The field to the
ZyXEL NWA-3100 User's Guide