Uploading Configuration File Via Console Port; Example Xmodem Configuration Upload Using Hyperterminal; Figure 157 Menu 24.7.2 As Seen Using The Console Port; Figure 158 Example Xmodem Upload - ZyXEL Communications NWA-3100 User Manual

22.4.9 Uploading Configuration File Via Console Port

1 Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu
24.7.2 – System Maintenance – Upload System Configuration File. Follow the
instructions shown in the next screen.

Figure 157 Menu 24.7.2 as seen using the Console Port

Menu 24.7.2 - System Maintenance - Upload System Configuration File
2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.
3 Enter "atgo" to restart the ZyXEL Device.

22.4.10 Example Xmodem Configuration Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 158 Example Xmodem Upload

ZyXEL NWA-3100 User's Guide
Chapter 22 Firmware and Configuration File Maintenance
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)
Type the configuration
file's location, or
click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
215