Figure 38 Network > Wireless Lan > General - ZyXEL Communications NBG-460N User Manual

Channel
Security
Follow the steps below to configure the wireless settings on your NBG460N.
The instructions require that your hardware is connected (see the Quick Start Guide) and you
are logged into the web configurator through your LAN connection (see
37).
1 Open the Wireless LAN > General screen in the AP's web configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the
Pre-Shared Key field. Click Apply.
Figure 38 Network > Wireless LAN > General
5 Open the Status screen. Verify your wireless and wireless security settings under Device
Information and check if the WLAN connection is up under Interface Status.
NBG460N User's Guide
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Chapter 6 Tutorials
Section 3.2 on page
77