ZyXEL Communications NBG-460N User Manual page 124

Chapter 8 WAN
Table 45 Network > WAN > Internet Connection: PPTP Encapsulation
LABEL
Password
Retype to Confirm
Nailed-up Connection
Idle Timeout
PPTP Configuration
Server IP Address
Connection ID/Name
Get automatically from
ISP
Use Fixed IP Address
My IP Address
My IP Subnet
Mask
WAN IP Address Assignment
Get automatically from
ISP
Use Fixed IP Address
My WAN IP
Address
DNS Servers
First DNS Server
Second DNS Server
Third DNS Server
WAN MAC Address
Factory default
Clone the computer's
MAC address
Set WAN MAC
Address
Apply
Reset
124
DESCRIPTION
Type the password associated with the User Name above.
Type your password again to make sure that you have entered is correctly.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the NBG460N
automatically disconnects from the PPTP server.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Type the (static) IP address assigned to you by your ISP.
Your NBG460N will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the NBG460N.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
Select From ISP if your ISP dynamically assigns DNS server information (and
the NBG460N's WAN IP address). The field to the right displays the (read-
only) DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined,
but leave the IP address set to 0.0.0.0, User-Defined changes to None after
you click Apply. If you set a second choice to User-Defined, and enter the
same IP address, the second User-Defined changes to None after you click
Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a computer in order
to access it.
The MAC address section allows users to configure the WAN port's MAC
address by either using the NBG460N's MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC address.
Select Factory default to use the factory assigned default MAC Address.
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning. Once it is
successfully configured, the address will be copied to the rom file (ZyNOS
configuration file). It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG460N.
Click Reset to begin configuring this screen afresh.
NBG460N User's Guide