Table of Contents
Advertisement
Chapter 8 WAN
8.3.3 NetBIOS over TCP/IP
NetBIOS (Network Basic Input/Output System) are TCP or UDP broadcast packets
that enable a computer to connect to and communicate with a LAN. For some dial-
up services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
However it may sometimes be necessary to allow NetBIOS packets to pass
through to the WAN in order to find a computer on the WAN.
8.3.4 Auto-Bridge
In the rear panel of your NBG-417N, you can see four LAN ports (1 to 4) and one
WAN port. The WAN port is for your Internet access connection, and the LAN ports
are for your network devices. The WAN port has a different IP address from the
LAN ports.
When you enable auto-bridging in your NBG-417N, all five ports (4 LAN ports and
the WAN port) share the same IP address as shown in the figure below.
Figure 55 Autobridging Example
This might happen if you put the NBG-417N behind a NAT router that assigns it
this IP address. When the NBG-417N is in auto-bridge mode, the NBG-417N acts
as an AP and all the interfaces (LAN, WAN and WLAN) are bridged. In this mode,
your NAT, DHCP server and firewall on the NBG-417N are not available. You do not
have to reconfigure them if you return to router mode.
Auto-bridging only works under the following conditions:
• The WAN IP must be 192.168.x.y (where x and y must be from zero to nine). If
the LAN IP address and the WAN IP address are in the same subnet but x or y
is greater than nine, the device operates in router mode (with firewall
available).
• The device must be in Router Mode (see
information) for auto-bridging to become active.
98
IP Address: 192.168.1.20
Chapter 22 on page 191
NBG-417N User's Guide
for more
Advertisement
Table of Contents
Troubleshooting
