Appendix A Product Specifications And Wall-Mounting Instructions; Table 101 Hardware Features - ZyXEL Communications NBG-318S - V3.60 User Manual

A
P P E N D I X
Product Specifications and Wall-
The following tables summarize the NBG318S's hardware and firmware features.

Table 101 Hardware Features

Dimensions (W x D x H)
Power Specification
Ethernet ports
3-4 Port Switch
ENCRYPT
WPS button
Reset Button
Antenna
Operation Environment
Storage Environment
Distance between the
centers of the holes on
the device's back.
NBG318S User's Guide
Mounting Instructions
162 x 118 x 35 mm
120-240 VAC, 50/60 Hz
Auto-negotiating:
This auto-negotiation feature allows the NBG318S to detect the speed of
incoming transmissions and adjust appropriately without manual
intervention. It allows data transfer of either 10 Mbps or 100 Mbps in either
half-duplex or full-duplex mode depending on your Ethernet network.
Auto-crossover:
Use either crossover or straight-through Ethernet cables.
A combination of switch and router makes your NBG318S a cost-effective
and viable network solution. You can add up to three computers to the
NBG318S without the cost of a hub when connecting to the Internet through
the WAN port. You can add up to four computers to the NBG318S when you
connect to the Internet through a HomePlug connection. Add more than four
computers to your LAN by using a hub.
Pressing this button in for less than 3 seconds begins the powerline
connection setup process.
Pressing this button in for more than 10 seconds resets the network name
to a random value.
The WPS (WI-Fi Protected Setup) button is built into the rear panel. Use this
button to set up a WPS connection with another WPS enabled device.
Note: Upgrade your firmware to install this feature on your
device.
The reset button is built into the rear panel. Use this button to restore the
NBG318S to its factory default settings. Press for 1 second to restart the
device. Press for 5 seconds to restore to factory default settings.
The NBG318S is equipped with a 2dBi detachable antenna to provide clear
radio transmission and reception on the wireless network.
Temperature: 0º C ~ 40º C
Humidity: 20% ~ 90% RH (Non-condensing)
Temperature: -20º C ~ 60º C
Humidity: 20% ~ 90% RH (Non-condensing)
125 mm
A
239