Pptp Encapsulation - ZyXEL Communications NBG-318S - V3.60 User Manual

Chapter 8 WAN
Table 38 Network > WAN > Internet Connection: PPPoE Encapsulation
LABEL
Password
Retype to
Confirm
Nailed-Up
Connection
Idle Timeout
WAN IP Address Assignment
Get automatically
from ISP
Use Fixed IP
Address
My WAN IP
Address
Remote IP
Address
Remote IP
Subnet Mask
DNS Servers
First DNS Server
Second DNS
Server
Third DNS Server
WAN MAC
Address
Factory default
Clone the
computer's MAC
address
Set WAN MAC
Address
Apply
Reset

8.4.3 PPTP Encapsulation

Point-to-Point Tunneling Protocol (PPTP) is a network protocol that enables secure transfer of
data from a remote client to a private server, creating a Virtual Private Network (VPN) using
TCP/IP-based networks.
110
DESCRIPTION
Type the password associated with the user name above.
Type your password again to make sure that you have entered is correctly.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the router
automatically disconnects from the PPPoE server.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Enter the remote IP address (if your ISP gave you one) in this field.
Enter the remote IP subnet mask in this field.
Select From ISP if your ISP dynamically assigns DNS server information (and the
NBG318S's WAN IP address). The field to the right displays the (read-only) DNS
server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the field to the right. If you chose User-Defined, but leave
the IP address set to 0.0.0.0, User-Defined changes to None after you click
Apply. If you set a second choice to User-Defined, and enter the same IP
address, the second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not configure a
DNS server, you must know the IP address of a computer in order to access it.
The MAC address section allows users to configure the WAN port's MAC address
by using the NBG318S's MAC address, copying the MAC address from a computer
on your LAN or manually entering a MAC address.
Select Factory default to use the factory assigned default MAC Address.
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning. Once it is
successfully configured, the address will be copied to the rom file (ZyNOS
configuration file). It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG318S.
Click Reset to begin configuring this screen afresh.
NBG318S User's Guide