Figure 149 Management > Access Control > Logins; Table 103 Management > Access Control > Logins - ZyXEL Communications MES-3728 User Manual

Chapter 30 Access Control
• A non-administrator (username is something other than admin) is someone who can view
but not configure Switch settings.
Click Management > Access Control > Logins to view the screen as shown next.
Figure 149 Management > Access Control > Logins
The following table describes the labels in this screen.
Table 103 Management > Access Control > Logins
LABEL
Administrator
This is the default administrator account with the "admin" user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password
New Password
Retype to confirm Retype your new system password for confirmation
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give
users higher privileges via the CLI. For more information on assigning privileges see the CLI Reference
Guide.
User Name
Password
Retype to confirm Retype your new system password for confirmation
Apply
Cancel
266
DESCRIPTION
Type the existing system password (1234 is the default password when
shipped).
Enter your new system password.
Set a user name (up to 32 ASCII characters long).
Enter your new system password.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES-3728 User's Guide