where
<vlan-id>
=
This command deletes the specified VLAN ID entry from the static VLAN table. The following example deletes
entry 2 in the static VLAN table.
ras(config)# no vlan 2
31.6 Enable VLAN
Syntax:
vlan <vlan-id>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
31.7 Disable VLAN
Syntax:
vlan <vlan-id>
inactive
This command disables the specified VLAN ID in the SVLAN (Static VLAN) table.
31.8 Show VLAN Setting
Syntax:
show vlan
This command shows the IEEE 802.1Q Tagged SVLAN (Static VLAN) table.
An example is shown next.
For the
section of the last column, "-" is a port set to normal, "x" is a forbidden port and "F" is a fixed port.
AdCtl
For the
section of the last column, "T" is a tagged port, "U" is an untagged port.
TagCtl
IEEE 802.1Q Tagged VLAN Commands
The VLAN ID [1 – 4094].
Figure 31-9 no vlan Command Example
Dimension ES-3124PWR Ethernet Switch
31-7