ZyXEL Communications Dimension ES-3124PWR User Manual page 188

Dimension ES-3124PWR Ethernet Switch
LABEL
VID This is the VLAN ID and is only applicable if the switch is set to 802.1Q VLAN. All switches
must be directly connected and in the same VLAN group to belong to the same cluster.
Switches that are not in the same VLAN group are not visible in the Clustering Candidates
list. This field is ignored if the Clustering Manager is using Port-based VLAN.
Apply Click Apply to save these changes to the switch.
Cancel Click Cancel to begin configuring this part of the screen afresh.
Clustering Candidate The following fields relate to the switches that are potential cluster members.
List A list of suitable candidates found by auto-discovery is shown here. The switches must be
directly connected. Directly connected switches that are set to be cluster managers will not
be visible in the Clustering Candidate list. Switches that are not in the same management
VLAN group will not be visible in the Clustering Candidate list.
Password Each cluster member's password is its web configurator password. Select a member in the
Clustering Candidate list and then enter its web configurator password. If that switch
administrator changes the web configurator password afterwards, then it cannot be
managed from the Cluster Manager. Its Status is displayed as Error in the Cluster
Management Status screen and a warning icon (
below.
If multiple devices have the same password then hold [SHIFT] and click those switches to
select them. Then enter their common web configurator password.
Add Click Add to save these changes to the switch.
Cancel Click Cancel to begin configuring this part of the screen afresh.
Refresh Click Refresh to perform auto-discovery again to list potential cluster members.
The next summary table shows the devices selected for clustering.
Index This is the index number of a cluster member switch.
MacAddr This is the cluster member switch's hardware MAC address.
Name This is the cluster member switch's System Name.
Model This is the cluster member switch's model name.
Remove Select this checkbox and then click the Remove button to remove a cluster member switch
from the cluster.
Cancel Click Cancel to begin configuring this part of the screen afresh.
26-6
Table 26-4 Configuring Cluster Management
DESCRIPTION
) appears in the member summary list
Cluster Management