Setting Up; Inserting And Testing Batteries (Pt 40 Pro And Pt 40 Flexx); Connecting A Microphone/Instrument (Pt 40 Pro) - AKG PT 40 FLEXX User Instructions

PT 40_2008_Hex:Layout 1
3.1 Inserting and Testing
Batteries (PT 40 PRO and
PT 40 FLEXX)
Fig. 3: Inserting the battery
into the PT 40 PRO or PT 40
FLEXX bodypack transmitter.
Refer to fig. 3.
3.2 Connecting a Micro-
phone/Instrument
(PT 40 PRO)
Fig. 4: Connecting a micro-
phone or instrument.
Refer to fig. 4.
20
01/17/2008 09:52

3 Setting Up

1. Depress the snap hook on the battery compartment lid (1).
2. Pull the battery compartment lid (1) off the transmitter in the direction of the arrow.
3. Insert the supplied battery into the battery compartment conforming to the polarity marks.
The transmitter will not function if you insert the battery the other way round.
4. Set the on/off switch (2) to "ON" to switch power to the transmitter on.
If the battery is in good condition, the status LED (3) will be lit green.
If the status LED (3 is lit red, the battery will be dead within about two hours. Replace
the battery with a new one as soon as possible.
Note: • If you use a rechargeable battery, the LED will switch to red 15 minutes before the bat-
tery will be dead!
If the status LED (3) fails to illuminate the battery is dead. Insert a new battery.
5. To close the battery compartment, slide the battery compartment lid (1) onto the battery
compartment from below to the point that the snap hook will engage.
1. Remove the battery compartment lid (1).
2. a) Plug the mini XLR connector on the cable of your microphone into the audio input
socket (2) on the bodypack transmitter.
b) Plug the jack plug on the MKG L guitar cable into the output jack on your instrument
and the mini XLR connector on the guitar cable into the audio input socket (2) on the
bodypack transmitter.
Seite 20 (Schwarz/Black Auszug)
PT 40 PRO/FLEXX