Microphones, Guitar Cable - AKG PT 40 FLEXX User Instructions

PT 40_2008_Hex:Layout 1
9 GAIN: This rotary control inside the battery compartment allows you to match the body-
pack transmitter input gain to the microphone or instrument you connected to the trans-
mitter.
10 Carrier frequency label: The label on the transmitter rear panel indicates the name of
the carrier frequency band and the three carrier frequencies of your transmitter. Refer
to the Manual Supplement sheet for a color code table.
The PT 40 PRO and PT 40 FLEXX bodypack transmitters have been designed for use with
the following AKG microphones:
• CK 55 L, C 417 L, C 520 L, C 555 L
• C 516 ML, C 518 ML. C 519 ML
If you wish to connect other microphones from AKG or other manufacturers to your bodypack,
please note that you may have to rewire the existing connector on your microphone or re-
place it with a 3-pin mini XLR connector.
Audio input pinout:
Pin 1: shield
Pin 2: audio inphase (+)
Pin 3: supply voltage
A 4-V positive supply voltage for condenser microphones is available on pin 3.
• The MKG L guitar cable from AKG lets you connect an electric guitar, electric bass, or
remote keyboard to the bodypack transmitter. The MKG L guitar cable is included in the
Instru mental Set SINGLE, Instrumental Set DUAL, and Instrumental Set FLEXX. It is also
available separately as an accessory.
• Please note that AKG cannot guarantee that the PT 40 FLEXX bodypack trans-
mitter will work perfectly with products from other manufacturers, and any da-
mage that may result from such use is not covered by the AKG warranty scheme.
PT 40 PRO/FLEXX
01/17/2008 09:52 Seite 19 (Schwarz/Black Auszug)
2 Description
2.6 Microphones,
Guitar Cable
L
Important!
19