AKG PR 40 User Instructions page 16

strips and attach it to the receiver
rear panel.
4. Remove the backing from the other
strip and attach it to the mixer, pedal-
board, or camera.
Fig. 6: Optimum antenna position.
To ensure perfect reception, position
the Velcro strip so that the antennas
on the receiver will protrude above
the mixer, pedalboard, or camera.
(Refer to fig. 6).
16
4.1.1 Audio Connection (Fig. 7)
The supplied connecting cable lets you
connect the line output on the receiver
to an audio input on a mixing console,
pedalboard, or video camera.
1. Check what connector type you will
need for your equipment and solder
the connector to the cable.
Cable pinout:
Red wire: line level
White wire: headphone signal
Shield: ground
Important: Please refer to the instruc-
tion manual of the equipment to
which you will connect the receiver
to check which wire you should
connect to which pin on the
connector.
2. If the selected input provides phan-
tom power, switch the phantom
A B
Fig. 7: Audio connection
power OFF.
Refer to the manual of your equip-
ment.
3. Plug the .1-in. jack plug (1) on the
connecting cable into the output jack
(2) on the receiver.
,